Chapter 9 Remote Communication Control
79
Remark
1) Cautions for Remote 1 connection and Remote 2 connection
(1) Following menu item can’t be available when XG-PD present open project and remote 1 and 2
connected CPU type are not well matched.
a) Program and Write each parameter
b) Program and Read each parameter
c) Monitor
d)Set Flash memory
e)Enable Link setting
f) I/O information
g) Force I/O
h) Skip I/O
(2) In case of programming by connecting XG-PD as remote 1 and 2, open the right project of
connecting station and then execute connection.
(3) Remote connection provides only by remote 2. Over remote 2 is not available.
To Next Page
Loading...