LOADER REMOVAL
CAUTION:
CAUTION:
Neverparkloaderwithoutbucket
attached to the loader.
Never allow weight of tractor to be put
on parking leg when removing loader.
▶ Park the tractor and loader on hard level
surface.
▶ Raise the boom until the bucket is about 2
feet off the ground.
▶ Disconnect the quick couplers on the
hydraulic hoses.
▶ Stop the engine and move the control lever
back and forth, left and right several times to
reduce the hydraulic pressure in the hoses.
▶ Move the tractor backword slowly and stop
to avoid the hydraulic hoses being tighten.
▶ Pull the control lever to raise the loader until
the post lift off mounting frame.
Adjust the bucket until the bottom surface of
bucket touch the ground.
▶ Set the Parking legs with pin-hand and
Keeper.
▶ Lower the boom until the Parking legs
make contact on the ground.
▶ Remove the latch pin while move the control
lever back and forth slightly to make the latch
pin easy.
Tip the bucket until the bucket cutting edge
touch the ground.
- 15 -
To Next Page
Loading...
