To Next PageTo Next Page
Need help?Do you have a question about the LS tractor LM1160 and is the answer not in the manual?
General| Number of Cylinders | 4 |
|---|---|
| Hydraulic System | Open Center |
| Engine Make | LS |
| Engine Type | Diesel |
| PTO Speed | 540 rpm |
| Tire Size - Rear | 18.4 |
Details of warranty for LS Mower parts and defects.
Purchaser's obligations for warranty validity and claims.
Manufacturer's right to alter products without prior notice.
Safe operation of the tractor, including controls and environment.
Safe operation of the mower, including attachment and guards.
Guidelines for safely transporting the mower and tractor.
Precautions during maintenance and service operations.
Warnings and precautions related to hydraulic system fluids.
Safe operating procedures, pre-operation checks, and work area considerations.
Instructions for maintaining and correctly applying safety decals.
Technical specifications for the LM1160 mid-mower, including dimensions.
Key performance metrics like blade speed, gear ratio, and weight.
Explains the manual's aim and how to use it effectively.
Locating and recording the mower's serial number for reference.
Instructions for safe and effective mower operation, including speed and cutting.
Advice on optimal mowing conditions, grass height, and time of day.
Step-by-step instructions for installing the mower mounting kit.
Steps for attaching the mower deck to the tractor.
Procedures for setting the mower deck after installation.
Adjusting left/right, front/rear cutting heights and settings.
Adjusting the mower deck's transfer height for level ground operation.
Instructions for safely removing the mower deck from the tractor.
Important cautions and warnings before performing maintenance.
Information on checking and replacing gear box oil.
Identifies grease points and service intervals for lubrication.
Instructions for checking, sharpening, and replacing mower blades.
Procedures for replacing the mower drive belt.
Causes and solutions for streaking and stinger patterns in mowing.
Identifying and fixing causes of uneven or scalped lawn cuts.
Causes and solutions for stepped or ridged lawn cuts.
Diagnosing and correcting common problems like non-raising, rough cut, and stalling.
Table of minimum hardware tightening torques for assembly.
Explains part illustration conventions and part ordering process.
Diagram showing the exploded view of the mid-mower assembly.
Diagram showing the exploded view of deck assembly components.
Diagram showing the exploded view of the center pulley assembly.
Diagram showing the exploded view of the side pulley assembly.
Diagram showing the exploded view of the tensioner assembly.
Diagram showing the exploded view of the wheel assembly.
Identifies locations and types of decals on the mower.
Defines key terms for deck components with diagrams.
Defines key terms for linkage components with diagrams.
Explains how power is transmitted from the PTO to the blades.
Describes how the tractor's hydraulic system lifts the mower.
Steps to remove the drive joint and belt cover.
Procedure for removing mower blades.
Steps for removing the gear box and mower belt.
Procedure for disassembling the center housing.
Detailed steps for disassembling the gear box components.
Procedure for disassembling the side pulley and blade shaft.
Steps for disassembling the tensioner pulley.
