LS tractor MT122 - How to drive and stop

4 -4
4-2. How to drive and stop
(1) How to drive
7. If pressing the brake pedal or turning off the
cruise control switch, the cruise control
mode shall be quitted.
6. If necessary, press down the symbol part of
the cruise control switch fix the driving speed
constantly.
1. Pull the position control lever to lift the
implement up after starting engine
2. Set engine speed at 1500 rev/min.
3. Place the range shift lever to the suitable
position.
4. Press the brake pedal and release the
parking brake.
5. Press the HST pedal slowly forward or
backward to move the tractor.
▶For HST model, there is a switch to control engine cut-off for driver’s safety. If the
operator leaves the driver’s seat without proper action for safety, the engine shall
be stop automatically. (For further information about seat, see page 2-2)
▶ When you drive HST type tractor, run the engine speed more than 1500 rev/min
for stability of hydraulic system.
▶ Press down the HST pedals slowly to prevent the sudden start of the tractor.
Notice
HST type
Range gear lever
Throttle lever
HST pedalsBrake pedal
Position control lever
Down
Up
Cruise control switch