5 -47
▶ Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.
To help prevent possible injury, turn the key switch off when changing fuel filters or
water separator elements. Clean up fuel spills immediately.
Warning
▶ Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel
system component that will be disconnected. Fit a suitable cover disconnected fuel
system component. Do not fill the new filter with fuel. Invisible fine contaminants
can enter the injection pump and it may cause damage to the fuel injection system.
Caution
▶Cover the bleeding fuel with a rag so that it does not flow into other components.
▶Do not throw the exhausted waste fuel to any place. This may pollute the soil and
water seriously and also is prohibited legally. If violating, you would be responsible
for that by civil or criminal case. The waste oil must be disposed according to the
environment laws.
Caution
▶ Escaping fluid!
Hydraulic fluid or diesel fuel leaking under pressure can penetrate the skin and
cause infection or other injury. To prevent personal injury: Relieve all pressure
before disconnecting fluid lines or performing work on the system. Before applying
pressure, make sure all connections are tight and all components are in good
condition. Never use your hand to check for suspected leaks under pressure. Use
a piece of cardboard or wood for this purpose. If injured by leaking fluid, see your
doctor immediately.
Failure to comply could result in death or serious injury.
Warning
Fuel injection pipe
② Air-bleeding from Fuel injection pipe
DO NOT loosen the high-pressure fuel lines in
order to purge air from the fuel system. This
procedure is not required.
To Next Page
Loading...
Need help?
General
