5 -14
(9) Tightening state of bolt and nut of each part
z Check if the bolts or nuts of each part are loosened and if loosened, tighten it again.
z Especially, check the bolts and nuts of the tires before starting engine, if necessary, tighten them.
(10) Adjustment of Clutch pedal
play (Mechanical type)
z Normal distance : 20~30mm (0.79~1.18 in.)
if the distance is over 20mm (0.79 in.),
adjust it as below.
1. Loosen locking nut and turn adjuster to adjust.
2. If the adjuster is tightened, the pedal play shall be
decreased, and if adjuster is loosened, it shall be
increased.
3. After adjusting the pedal play, tighten the locking
nut.
4. Check if the clutch is disengaged completely.
Brake pedal
Adjuster
Locking nut
(11) Adjustment of Brake pedal play
z Normal distance : 50~60mm. (1.96~2.36 in.)
If the pedal play distance is over 60mm (2.36 in.),
adjust it as below.
1. Loosen the locking nut and turn brake rod to adjust.
2. If brake rod is tightened, the pedal play shall be
reduced and if brake rod is loosened, it shall be
increased.
3. After adjusting the pedal play, tighten the locking
nut.
4. Check if the brake distance of the left and right
brake is same as below.
z Checking the brake distance
1. Connect left and right brake pedal using
connecting pin.
2. Check the skid mark of the tire or stability of the
tractor while driving at a suitable speed.
3. If the brake distance is different as shown in the
right figure, adjust the pedal play again.
Left/ Right brake distance
is different.
Normal
2
0
~
3
0
m
m
Clutch pedal
Locking nut
Adjuster
Clutch rod
5
0
~
6
0
m
m
To Next Page
Loading...
