5 -22
(4) Replacing Air cleaner element
(Dry type)
z Remove the cover and pull the primary element
straight out, ensuring the safety filter element
remains in place.
z Clean the inside of the air cleaner housing using
a clean damp cloth, taking care not to damage
the safety element.
z Check if there is damage inside filter element by
using a light. If finding tiny crack or small holes
in the filter element or the gasket is damaged,
change it with a new one.
z Insert the filter element by pushing it deeply into the filter housing.
z Remove the dust of the evacuator valve and clean the inside of the cover.
z Assemble the cover with the evacuator valve placed downward.
▶ Do not start the engine or close the hood if the filter element is not assembled..Notice
Cover
Primary
element
Evacuator
valve
Safety filter
element
(5) Toe-in
z Check and adjust Toe-in of the front wheel as
follow.
Normal value ; B - A = 0~5 mm (0~0.2 in.)
z Unscrew the lock nuts of the tie rod.
z If you turn the tie rod clockwise at right hand side
“B-A” shall be increased.
z After checking that Toe-in is correct, tighten the
lock nuts.
A
Lock nut
Lock nut
FRONT
B
Tie rod
To Next Page
Loading...
