3 -14
(13) Shuttle lever (Mechanical)
z This is used to select Forward or Reverse.
z Forward : push the lever forward.
Reverse : pull the lever backward.
z Before reversing the tractor, lower the engine
rpm and check the safety behind the tractor.
▶The operation of shuttle lever must be done after the tractor has stopped
completely. DO NOT operate the shuttle lever while tractor is moving. It may cause
a damage of synchronizer rings and gears.
Caution
Forward
Backward
Shuttle lever
(15) Throttle pedal (Mechanical)
z This pedal is used to control engine speed when
running on the road.
z When using the Throttle pedal, the throttle lever
must be placed on Low speed.
z An electronic control sensor is attached on this
pedal. If there is an error relating with this sensor
while the engine is running, the engine speed
shall be fixed to 1500 rev/min, so called LIMP
HOME mode. Contact your authorized dealer.
Throttle pedal
(14) Throttle lever
z This lever is used to control engine speed.
- Pull it backward for Low speed,
- Push it forward for High speed.
z The throttle lever must be used only for work
field. When driving on the road, place the throttle
lever to low speed, and use the throttle pedal.
z For HST model, An electronic control sensor is
attached on this lever. If there is an error relating
with this sensor while the engine is running, the
engine speed shall be fixed to 1500 rev/min, so
called LIMP HOME mode. Contact your
authorized dealer.
Throttle lever
High speed
Low speed
To Next Page
Loading...
