2 -8
(4) Roll-Over Protective Structure (ROPS) (optional)
① Roll-bar (Safety frame)
z As the Roll-bar is very important structure for
driver’s safety, DO NOT modify (welding, drilling,
cutting, etc) or remove it arbitrary.
z When folding the Roll-bar for special work,
comply with the following instructions.
1. Loosen the bolts ①, ② on both sides.
It is not necessary to remove it completely.
2. Pull out the pins on both sides and fold upper-
frame down carefully.
Be careful of the possibility that your body might
be hurt by sudden folding due to its weight.
3. Insert the pin into the holes in order to fix the Roll-
bar.
4. Tighten the bolts ①, ② firmly on both sides.
z Do stand the Roll-bar up originally as soon as
your special work is finished.
Warning
▶ Do not change or disassemble the Roll-bar arbitrarily for driver’s safety.
▶ Unless the Roll-bar is installed correctly, it may cause a serious accident on tractor
when being overturned.
- Be sure to stand the Roll-bar up firmly and assemble the bolts, pins and nuts
correctly.
▶ When folding the Roll-bar;
- Do cooperate with more than 2 people when folding or standing up the Roll-bar
as it’s heavy.
- Be careful not to be injured by sudden folding, which might occur when folding or
standing up the Roll-bar, results from its weight.
- Do not wear seatbelt when the Roll-bar is folded down.
② Cabin
z The Protective Structure (Roll-bar or Cabin) and interconnecting components are a certified system.
Any damage, Fire, corrosion or modification will weaken the structure and reduce your protection. If
this occurs, the Protective Structure MUST be replaced with a new one. Contact your authorized
dealer for Protective Structure inspection and replacement.
Warning
▶As the cabin is very important structure for driver’s safety, DO NOT modify (welding,
drilling, cutting, etc) or remove it arbitrarily.
▶Do not step on the fender for the maintenance of cabin roof.
Bolt②
Bolt①
Pin
To Next Page
Loading...
