Chapter 4. System Configuration
If you select the image through [Set Background Image], background image of waiting
screen is set as the selected image. If you want to cancel, press [Delete Background
Image]
[Background Image Selection Screen]
[Use boot image] With an option selected, you cannot use it unless it is the image of
different resolution from that of XGT Panel or 32-bit image.
Clear SRAM memory and
data files
All files downloaded by the user are deleted. If connection password is set, you have to
input the password. This password is connection password needed for project
download, etc. You can set that password in [Communication]
[XGT Panel Information] [Password] tap. The deleted files are user project file, web
server, VNC start module, option card driver, RAPIEnet communication setting data,
XP-manager setting data and etc. Setting through Environment Setting menu of device
is not initialized.
Reset USB power after boot
up
When XGT Panel starts, USB power state is converted from Off to On initializing the
connected device.
Show progress on the
bottom
It indicates title bar on pop up window. With title bar of pop up window selected, it may
move the location.
This function is used for improving XGT Panel. If you select this mode, XGT Panel will
load the original images and decrease memory using.
It enables the language indicated from right to left directions.
Show always title bar of
popup window
It indicates title bar on pop up window. With title bar of pop up window selected, it may
move the location.
When the monitor starts, the screen will be shown as following inputted number
When the monitor starts with XGT Panel button [Start] pushed, it outputs 5V power
using No. 9 pin of RS-232C Port. When turning off XGT Panel monitor and returning to
menu screen again, it stops power output.
To Next Page
Loading...