11
table area, etc.
Figure 4.2 Initial Interface
Note: In the point cloud display area (right side), with 20 circles and 40*40 grids,
the radius of each two adjacent circles differs by 10 m. The difference between
each two grids (horizontal or longitudinal) is 10 m. And the radius of the
outermost circle is 200 m.
The grids and circles make it easy to view the position of the point cloud. The
direction of the coordinate axis in the 3D display interface is consistent with the
direction of the X-Y axis in the point cloud reference system.
Note: To view the software version, click “Help->About” in the tool bar.
Point cloud display interface supports the following operations:
1) Zoom in/out the display interface with the mouse wheel; hold the right mouse
button and drag it up/down to zoom in/out.
2) Hold the left mouse button and drag it to adjust the angle of view;
3) Hold the mouse wheel and drag it to pan the display interface; or hold the
shift key on the keyboard and the left mouse button to pan the interface.
Menu button function introduction
⚫ Lidar Menu
To Next Page
Loading...