E-mail: support@lslidar.com Phone: 0086-0755-23242821 Website: www. lslidar.com Linkedin: LeiShen Intelligent System 16
4.2.3 Adapter Board
The adapter board was offered as accessory, transfer HY2.0-6P to Type-C USB, which realizes TTL TO USB data conversion. It is to facilitate
customers for debugging use. However, this adapter board is not a necessary device for LiDAR operation.
Following picture is the instruction for each module in adapter board.
①
Type-C USB: data communication and system power supply;
②
Micro USB: Power supply only. When the power supply capacity of the Type-C USB port is insufficient, the port can be
③
used for additional auxiliary power supply;
④ K1: Power switch;
⑤ LIDAR: connect to radar;
⑥ GPS: Connect GPS module
To Next Page
Loading...