E-mail: support@lslidar.com Phone: 0086-0755-23242821 Website: www. lslidar.com Linkedin: LeiShen Intelligent System
39
8. Instrument Maintenance
8.1 Transportation requirement
M10 uses specially customized packaging materials , which can resist certain vibration and impact. Special packaging materials must be used for
long-distance transportation to avoid irreversible damage during transportation.
8.2 Installation
Secure to the base with screws to specifications, paying attention to heat dissipation of the base. Wear powder-free clean gloves during installation
to avoid dirt and mechanical damage of the mask.
8.3 Storage Conditions
M10’s storage temperature is -40°C~85°C. It is recommended to store the products in a ventilated and dry place, at normal temperature (23±5°C)
and relative humidity (30~70%). The products are not waterproof, and cannot be stored in humid environment malaise of pH.
8.4 Clean
If the enclosure is dirty during use, it will directly affect the LiDAR ranging effect, such as finger marks, muddy water lumps, dried leaves or insect
corpses .Please clean as follow：
Tools: PVC gloves, dust free cloth, absolute alcohol (99%)
Environment: ventilated and dry, away from fire source
●Wear PVC gloves to secure the LiDAR base ; If it is not a stubborn stain, use a dust-free cloth or dry air to gently brush away the dirt；
●For stubborn stains, spray evenly with ethanol spray where cleaning is required. After dissolving the stain, use a dust-free cloth to dip in ethanol
solvent and gently wipe the enclosure. If the dust-free cloth is contaminated, replace it in time. After cleaning , use a new dust-free cloth to remove
the remaining liquid.
To Next Page
Loading...