Model 3000 Survey meter User’s Manual Section 9
Ludlum Measurements, Inc. Page 9-2 April 2021
March 2017: Firmware was updated, which affects Section 2 with
more screens at turn-on and changes in what buttons do and how to
press/tap them. Updated Audio in Section 3 Specifications. In Section
4 updated Default Values including adding P5 values, added a note on
page 4-3 before Setup Protect explanation, added sentence about
backlight configuration in note at end of Entering Setup Mode section
on page 4-4, detailed types of presses/taps in setting up pages, changed
values of Dead Time Correction 2 Exponent (Default 0) to -6 to -12,
added Dual Level Audio default at end of Setup page 4. Added Section
5 Datalogging. Section 6 updated to Software with Connecting to
Software and Extended Features as sub-sections. Added Section 10
Options.
October 2017: Corrected presses/taps where necessary in Sections 2
and 4. Corrected ON/ACK to ON/OFF throughout. Added Auxiliary
Communication in Section 2. Replaced the Default Values table on
page 4-2 with the Setup Parameters table. Added description of Setup
page 5 in Section 4. Added Advanced Features as Section 7.
October 2018: Datalogging is no longer an “option” but a standard
feature with the logging button as standard on the handle, updated
photo on inside cover, added paragraph at end of Section 1, deleted
3000 Series Datalogging Option in Section 11. Updated to two alarms
in Section 4. Made corrections to first paragraph of Section 6, under
Connecting to Software. Changed part # for unimorph with harness in
Section 12 from 8498-542 to 8498-542-01. Updated Drawing 498 x
409K. Removed AuxComm section from Section 2 to and moved it to
a dedicated Appendix A where more detail was added.
September 2019: Added paragraph about dead time correction to
Section 1, page 1-2, also added Dead Time Correction to Section 3
Specs. Updated NEMA rating on page 3-2 from 4x to 5.
November 2020: Added Linearity to Specifications, page 3-1.
March 2021: Firmware updated to version n34, and this manual covers
n34 only, which has only one alarm; all references to two alarms
deleted. Updated Setup Protect section in Section 4, starting on page 4-
4. On page 5-4 under Datalogging Operation – Mode 3 in second
bullet point, changed “SCALER Mode” to “COUNT mode.” Deleted
Instrument Calibration section in Section 7, page 7-3, due to
redundancy. In Section 12, updated Main Board part # from 5498-440
to 5519-042. In Appendix A Auxiliary Communications, page A-6,
deleted Setting 5 Simple Counts.
April 2021: Removed Extended Features from Section 6 Software,
pages 6-2 and 6-3. Removed AuxComm Mode 5 column in table under
Settings on Particular Models on page A-9.
To Next Page
Loading...
