Ludlum Measurements 3000 - AuxComm Settings Configuration

Model 3000 Survey meter User’s Manual Appendix A
Ludlum Measurements, Inc. A-5 April 2021
Settings
The settings for AuxComm are only configurable through software. See Figure 20.
Figure 20: Example – Lumic Calibration Software AuxComm Menu
AuxComm Setting - Enabled
This setting enables or disables the AuxComm port. If this is set to “Off,” the port is
completely disabled and will stay that way until set to “On.”
Note:
When AuxComm is “Off,” the hot-key to turn AuxComm on and off on the fly will
not function.
Table A-1: AuxComm Enabled
Setting
State
0
Off
1
On
AuxComm Setting - Mode
The mode setting for AuxComm configures how the port will function. Table A-2 lists the
modes and their baud rates.