Model 3000 Survey meter User’s Manual Appendix A
Ludlum Measurements, Inc. A-2 April 2021
Figure 14: Example – Printed Circuit Board (PCB) number location.
Usage
Usage of the AuxComm port is generally very simple from the user’s perspective. Most
modes only require everything to be plugged in and then should “just work.” However, there
are a couple of caveats.
If using the SLURM protocol, the user will need to pair the instrument with a mobile device
using the hot-key listed below.
AuxComm Usage - Hot-key
The hot-key is triggered by simultaneously pressing the UNITS and MODE buttons as seen
in Figure 15.
There are two types of hot-key presses:
1 second: If the hot-key combination is held for a little over 1 second (but less than
2), the AuxComm port will toggle on and off each time this is done.
To Next Page
Loading...
