56
Adjust the Z-offset by turning the knob
counter-clockwise to raise the value, or clockwise to
lower it. The Z-offset is a negative number, with zero
being identified as the top of the heat bed washers.
A larger negative Z-axis value brings the hot end nozzle
closer to the print surface. A smaller negative Z-axis
value will move the nozzle further away from the print
surface.
When you have adjusted or restored your Z-offset,
select Store Settings from the Configuration menu
to save it. You will hear a beep, indicating that the
settings have been successfully saved.
Z-axis Offset Adjustment: Cura LE
Connect to your LulzBot 3D Printer using the supplied
USB cable and open the console found in the
monitor tab.
Type in M851 and press enter to view your current
Z-offset.
To Next Page
Loading...
