MCS640 Thermal Imager Manual General • 6
authorized radio station, by another intentional or unintentional radiator, by industrial, scientific and medical
(ISM) equipment, or by an incidental radiator.
The operator of a radio frequency device shall be required to cease operating the device upon notification by a
Commission representative that the device is causing harmful interference. Operation shall not resume until
the condition causing the harmful interference has been corrected.
1.4 Limit of liability and warranty
All general information and notes for handling, maintenance, and cleaning of this instrument are offered
according to the best of our knowledge and experience.
LumaSense Technologies is not liable for any damages that arise from the use of any examples or processes
mentioned in this manual or in case the content of this document should be incomplete or incorrect.
LumaSense Technologies reserves the right to revise this document and to make changes from time to time in
the content hereof without obligation to notify any person or persons of such revisions or changes.
All instruments from LumaSense Technologies have a regionally effective warranty period. Please check our
website at http://info.lumasenseinc.com/warranty
for up-to-date warranty information. This warranty covers
manufacturing defects and faults which arise during operation, only if they are the result of defects caused by
LumaSense Technologies.
The Windows compatible software was thoroughly tested on a wide range of Windows operating systems and
in several world languages. Nevertheless, there is always a possibility that a Windows or PC configuration or
some other unforeseen condition exists that would cause the software not to run smoothly. The manufacturer
assumes no responsibility or liability and will not guarantee the performance of the software. Liability
regarding any direct or indirect damage caused by this software is excluded.
The warranty is VOID if the instrument is disassembled, tampered with, altered, or otherwise damaged
without prior written consent from LumaSense Technologies; or if considered by LumaSense Technologies to
be abused or used in abnormal conditions. There are no user-serviceable components in the instrument.
1.5 Unpacking the instrument
Before shipment, each instrument is assembled, calibrated, and tested at the LumaSense Factory. When
unpacking and inspecting your system components, you need to do the following:
1. Check all materials in the container against the enclosed packing list.
LumaSense Technologies cannot be responsible for shortages against the packing list unless a claim is
immediately filed with the carrier. Final claim and negotiations with the carrier must be completed by
the customer.
2. Carefully unpack and inspect all components for visible damage. If you note any damage or suspect
damage, immediately contact the carrier and LumaSense Technologies, Inc.
3. Save all packing materials, including the carrier’s identification codes, until you have inspected all
components and find that there is no obvious or hidden damage.
Note: LumaSense encourages you to register your product with us to receive updates, product
information, and special service offers: http://info.lumasenseinc.com/registration
.
To Next Page
Loading...
Need help?
General