Name: LumaSense technologies MCS640
Brand: LumaSense technologies
Rating: 5 (1 reviews)

To Next Page

To Previous Page

MCS640 Thermal Imager Manual Getting Started • 23

3.2.2 Set the IP Address

Note: Your instructions may vary slightly based upon which version of Windows you are using. These

instructions were written using Windows 7.

1. Access Network and Internet Settings by clicking Start, selecting Control Panel, and selecting

Network and Internet.

2. Click on Network and Sharing Center.

3. Click Change adapter settings.

Questions and Answers:

Need help?

Do you have a question about the LumaSense technologies MCS640 and is the answer not in the manual?

LumaSense technologies MCS640 Specifications

General