Luminex LumiNode 12 - Connection to the Network; LED Indicators

^>ϭϭƵŶŝƚƐŵŵ΀ŝŶĐŚ΁
$ $
% %
& &
' '
( (
) )
* *
+ +
























>ƵŵŝEŽĚĞϭϮ
&/Z^dE'>WZK:d/KE
Ϯ
/8


󾙔󾙔 
The LumiNode 12 can be powered with a power cable 󽘀tted with a Neutrik powerCON TRUE1 connector
(M) (please contact your local dealer if you do not have a suitable power cable at hand). The device will
automatically switch on. To shut it down after use, just un-plug the power cable again. The LumiNode 12
can also be powered with PoE (N).
The LumiNode 12 requires standard AC power distribution from 100-240VAC, 50/60Hz.
The mating Neutrik powerCON TRUE1 connector is supplied; however, you will need to purchase or
construct a cable appropriate for your application.
When installing a new connector please refer to the following wire colour code reference:
Wire* Connection
Green/Yellow AC Ground
Blue AC Neutral
Brown AC Line
* International (Harmonised) Standard
Alternatively, the LumiNode series are 802.3af compliant (PoE), so that each LumiNode will act as a
PD (Powered Device) and can be powered by any compliant PSE (Power Sourcing Equipment) such as
Ethernet switch, midspan and PoE injector. All models can only be powered with PoE via ETH2!
If both AC power and PoE are used the AC power supply will be prioritised, but the PoE will seamlessly take
over if the AC power fails.
The LumiNode 12 o󽗿ers the option to daisy chain up to 30 devices via the PowerCON TRUE1 outlet on the
rear of the unit.
󾙔󾙕 
To get the LumiNode 12 online in your system, connect either port ETH1 or ETH2 to a computer, or to a
port of an Ethernet switch.
Only port ETH2 on the rear of the unit can be used to power the unit through PoE. Check the port labelling
for a better identi󽘀cation.
󾙔
8