36
Installation - Surface mounting EN
Stipulate the positions of the dow-
el fixing of the wall installation
housing and the position of the
core bore of the wall break-
through pipe with the aid of the
drill template (= plaster protective
cover).
Manufacture the core bore for the
wall break-through pipe.
Drill the holes for the wall fas-
tening dowels.
Make available the mains cable
(and as appropriate, the control
lines).
Cable exit from the wall only in
the area marked on the drill tem-
plate.
Mount the wall break-through
pipe internally and externally with
slight protrusion for the bridging
of the plaster thickness! Keep to
the slope indicated in the illustra-
tion.
Clean the pipe externally.
Bore Ø: 8 mm
Core bore Ø:
162 mm
Cable exit
Mains cable
and control line
exit admissible
in this area
only
inner
outer
Plaster protective
3 mm
①
②
➂
To Next Page
Loading...
