Lust CDD3000-HF - Page 96

CDD3000-HF Operation Manual
Appendix B Index
A-22
K
KeyPad
KP200
....................................... 4-24
Operation
.................................... 4-24
KP200 display
..................................... 5-3
L
LED ................................................. 5-1
LEDs (H1,H2,H3)
................................... 5-1
Line choke
.......................... 2-3, 3-14, A-10
Low voltage directive
.............................. 1-2
LUST encoder cables
............................ 3-11
M
Mains connection ................................ 3-13
Mains filter
................................. 2-3, 3-15
Mains voltage asymmetry
....................... A-10
Master encoder
.................................. 3-25
Measures for your safety
.......................... 1-1
Mechanical installation
............................ 2-1
Menu structure
.................................. 4-24
Motor connection
.................................. 3-5
Motor filter
....................................... 4-16
Motor phase connection
.......................... 3-6
Motor temperature
Monitoring
.................................... 3-7
PTC
............................................ 3-7
Motor with plug connection
....................... 3-6
Motors with terminal boxes
....................... 3-7
Mounting
clearances
.................................... 2-3
collar
.......................................... 2-8
height
......................................... A-8
plate
........................................... 2-3
seal
............................................ 2-8
set CDD
....................................... 2-2
variants
........................................ 2-1
Mounting and cooling variants
.................... 2-1
N
Notes on operation ................................ 2-1
O
Optical encoders
Cable
........................................ 3-10
Overview
........................................... 3-2
KeyPad KP200
.............................. 4-24
Menu structure, KP200
..................... 4-24
P
PARA menu ...................................... 4-25
Pin assignment
............................ 3-9, 3-11
Positioning data
................................. 4-17
Power loss
......................................... 2-8
Power stage enable
............................. 4-19
Project planning notes
Cold plate
..................................... A-9
Encoder cable
................................. 3-8
Protection
.......................................... A-8
Pulse mode
........................................ A-4
Push-through heat sink (Dx.x
..................... 2-8
Q
Qualification, users ................................ 1-1
R
Reinitialization ..................................... 5-6
Repairs
............................................. 1-2
Reset
Device
......................................... 5-6
Parameters
.................................... 5-6
Resetting
........................................... 5-4
Resolver
............................................ 3-8
Resolver cable
..................................... 3-9
Responseno.
....................................... 5-2
Responsibility
...................................... 1-2
S
Safety ...................................... 1-1, 4-15
Sequence programs
............................. 4-17
Serial commissioning
............................. 4-2
DriveManager
................................. 4-2