Lust CDD34.003-HF - Saving Settings

CDD3000-HF Operation Manual
4-17
4 Commissioning
DE
EN
FR
IT
ES
FR
1
2
3
4
5
A
4.3.9 Saving settings
Saving the settings in the device
Any changes which are to be stored permanently in the device must be
saved by way of the
CDD3000-HF setup screen.
The changes made can also be saved to a file.
Saving the settings to a file
Depending on the preset solution, the CDD3000-HF has a range of data
sets which together form the device configuration.
Choose the file name (e.g. mydata). Then the data sets are selected
depending on the preset solution. All files are saved under the chosen file
names (e.g. mydata) with the appropriate extension (*.00D). The device
data can be assigned a description prior to saving.
Continue with:"Test run", see section 4.4.
DRIVEMANAGER
CDD3000-HF setup
or: Active device > Change
settings
Description of device data
Only with positioning,
fully programmable, PCx_4
Only with positioning,
fully programmable, PCx_4
D
RIVE
M
ANAGER
CDD3000-HF setup
or: Active device> Save device
settings to>file
Save…
Necessary with preset
solution
With KEYPAD
to S
MARTCARD
With
D
RIVEMANAGER
to file
Device data (=“Settings”)
(device settings and motor data)
All yes
yes
(*.00D), (*.00T),
(*.00X)
Positioning data (variables,
flags and table position of
sequence control)
Positioning, fully
programmable (PCT_4 PCB_4)
no
yes
(*.01D), (*.01T),
(*.01X)
Sequence programs
Positioning, fully
programmable (PCT_4 PCB_4)
no yes (*.prg)