10
Aurora
Battery Replacement
Using a #1 Phillips head
screwdriver, loosen the screw in
the battery door. Unscrew just
enough that the battery door
comes loose but the screw
remains attached.
Place a rubber band between your finger and the battery to
improve your grip.
Stick a piece of scotch tape to the battery and pull to remove.
Pull down gently to open the
battery door.
Slide the battery straight up
to remove.
1
Pull knob away from base
Option 1
Option 2
2
Loosen screw and open battery door
3
Slide to remove/install
WARNING: Risk of fire, explosion, and burns. May
result in serious injury or death. DO NOT recharge,
disassemble, crush, puncture, heat above 212 °F (100
°C) or incinerate the battery.
The battery in this device contains Perchlorate material,
special handling may apply. For more information, visit
www.dtsc.ca.gov/hazardouswaste/perchlorate
+
Grab the outside of
the knob and pull it
straight away from
the mounting base to
remove.
Tips for Removing the Battery
Selecting a Battery
NOTE: Due to natural oils on your finger, it can be difficult to slide
the battery out for removal. Many common household items
can help.
The Aurora dimmer is designed and tested with Panasonic
CR2032 batteries. For the best performance, it is recommended
that batteries are replaced using the same Panasonic battery.
To Next Page
Loading...
Need help?
General
