14
Aurora
Difficulty Mounting to a Toggle Switch
Aurora toggle tape is a solution for attaching the rotary dimmer to
older toggle switches made from a material to which the clamp
may have difficulty attaching.
Toggle tape may be required for switches manufactured before
1980. Toggle tape is optional and should only be used if the user
has tried to attach the mounting base, but was unable to securely
attach to the switch.
1
Clean the toggle switch
2
Apply tape
3
Install rotary dimmer as normal
Lightly apply isopropyl alcohol on a clean cloth and use it to
clean the switch. If you do not have isopropyl alcohol, damp-
ening a clean cloth with water is an acceptable substitute.
Ensure the toggle switch is dry, then apply the toggle tape to the
bottom of the toggle switch and carefully wrap around the top of
the switch (shown below).
With the tape now applied, squeeze the toggle switch between
your fingers to ensure it is firmly attached to the switch.
NOTE: Do NOT use scotch tape or any other household tape.
It will not work as directed.
NOTE: If you do not have toggle tape, please contact Lutron
Customer Assistance.
Install rotary dimmer as per instructions in the Mounting section.
To Next Page
Loading...
Need help?
General
