8
Aurora
Converting from Standalone to a Bridge System
NOTE: Please see the previous section for how to Restore Factory
Defaults to your Aurora dimmer.
NOTE: The lights that were previously connected directly to an
Aurora dimmer will not be automatically discovered by the app.
These can be added to the system by manually typing the serial
number on the light into the app.
If you previously had an Aurora dimmer connected to a lamp
without a bridge, and you wish to add it to a bridge system,
please follow the steps below, or reset the lights to factory
defaults as described on page 15.
1
Restore the Aurora dimmer to the factory defaults
2
Add the Aurora dimmer by following the prompts on
the app (see page 2)
To Next Page
Loading...