Lutron Electronics WAC-2019SD - Page 46

2) After Display unit is selected to " C " or " F ", press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
function with default.
12-8 Set DO salt% compensation value
When the " DO SALT % COMP. " text is yellow color
1) This function only for the DO ( Disolved oxygen ) mode
of adjusting the probe's salt% compensation value.
The default value is 0% salt.
2)
Press "Enter" into the setting function,Then use the "
▲
Button
" ( 3-5, Fig. 1 ) or "
▼
Button " ( 3-6, Fig. 1 ) to select the
upper value to the desired salt% compensation value,
then press the " Enter" Enter Button " ( 3-8, Fig. 1 ) will
save the setting value temporally.
12-9 Set DO height ( meter ) compensation value
When the " DO Hight (meter) COMP. " text is yellow color
1) This function only for the DO ( Disolved oxygen ) mode
of adjusting the probe's height compensation value in
meter unit. The default value is 0 meter.
2)
Press "Enter" into the setting function,then use the "
▲
Button
" ( 3-5, Fig. 1 ) or "
▼
Button " ( 3-6, Fig. 1 ) to select the
upper value to the desired height compensation value ( meter ),
then press the " Enter Button " ( 3-8, Fig. 1 ) will save the
setting value temporally.
44