Lutron Electronics WAC-2019SD - Page 47

12-10 Set DO height ( feet ) compensation value
When the " DO Hight (feet)COMP. " text is yellow color
1) This function only for the DO ( Disolved oxygen ) mode of
adjusting the probe's height compensation value in
feet unit. The default value is 0 FEET.
2)
Press "Enter" into the setting function,then use the "
▲
Button
" ( 3-5, Fig. 1 ) or "
▼
Button " ( 3-6, Fig. 1 ) to select the
upper value to the desired height compensation value ( feet ),
then press the " Enter Button " ( 3-8, Fig. 1 ) will save the
setting value temporally.
12-11 Set CD temperature compensation factor
When the " CD Temprature COMP. " text is yellow color
1) This function only for the Conductivity ( TDS ) mode of
adjusting the probe's Temp.compensation value in
% per
℃
unit. The default value is 2 % per
℃
.
2)
Press "Enter" into the setting function,then use the "
▲
Button
" ( 3-5, Fig. 1 ) or "
▼
Button " ( 3-6, Fig. 1 ) to select the
upper value to the desired Temp. compensation value
( %/per
℃
), then press the " Enter Button " ( 3-8, Fig. 1 )
will save the setting value temporally.
45