Luxman 308 - Outline of Control Functions; Front Panel Controls Overview; Tone and Filtering Controls

Oufline of Control Functions
-@ Speaker Selector @ Pilot Lamp
Choice of Main or Remote {or both) and Off. .
@® Input Selector Switch
© Bass Programme source (Phono, Tuner, Aux, etc.).
Inner axts for Left and outer axis for Right shanaele 3 io 3
Turn clockwise for bass boost. @® Attenuator =
Keep fully clockwise for normal use. Turning counter-
@ Treble clockwise reduces the volume up to 18 dB. Can be
Inner axis for Left and outer axis for Right channels. used as a volume level control when the amplifier
Turn clockwise for treble boost. section is used separately.
©
Linear
Equalizer
@
Volume
The “up tilt cuts bass and boosts treble. ““down-tilt”
cuts treble and boosts bass. (A full description @ Balance
appears on Page 16). Both channels are balanced at the mid-position. ‘
Q) Low Cut @® High Cut
OFF at NORMAL. ON at either 20 Hz or 70 Hz.
Useful for rumble filtering, etc.
' PEPER CETTE CARE
os SOLID STATE STERHO INTEGRATED =a
Fasc Wart
- pin UNIAR ERHIALHZER
amain & ceoente IREBtE up Hft.
nai
phono
. down!
| hed *
aes
: eT
remote.
OFF at NORMAL. ON at either 7 KHz or 12 KHz.
Useful for scratch filtering, etc.
low cut digglbeut manitor dudlsiny
Inw bnost Jus *KH: deck I ftoy
VOLUME -@- BALANCE
stereo
monat+®. .- So SO Pevorse
¢ ix
1Sf) re 60 1 aK
o
4 : = normal —~———-- FY — TY r. ) — ® = \OunCe . °
Em
frequent y/H7 tone He-festt dun? 1Km, declt-24rh ? Fol deck J otlenuate
@® Power Switch ® Monitor
Deck-1 or Deck-2/4ch for tape playback. For Phono,
© Phono Tuner, Aux, etc., set at SOURCE.
@® Dubbing
From Tape-1 to Tape-2, move to the upper position.
From Tape-2 to Tape-1, move to the lower position.
Otherwise, leave at SOURCE.
@ Mode Selector Switch
7) Treble Frequency Selector Stereo, Monaural selection, etc. .
Choice of turnover point from three frequencies. @ Deck-1 Reproduction Jack
Used in conjunction with the Monitor Switch for
playback from a tape-recorder.
For connection of stereo headphones.
@ Bass Frequency Selector
Choice of turnover point from three frequencies.
© Tone Controls Switch
When at NORMAL, it allows full tone control. When @ Deck-1 Recording Jack
at
LOW
BOOST,
it
gives
an
extra
bass
boost,
and
Used
in
conjunction
with
the
Monitor
Switch
for
when at DEFEAT, it provides a flat response. recording.