Luxman C-10X - How to Use Remote Control

20
How to use Remote Control
Remote controller (RA-20)
1
2
4
5
7
6
9
8
10
12
3
11
1. Operation button (OPERATION)
Turns this unit to the operating state after turning off the
standby indicator at the standby state. Pressing this button
again at the operating state turns the unit to the standby
state.
2. Input selector
(LINE-1, LINE-2, LINE-3, BAL-1, BAL-2,
BAL-3)
Selects the unbalanced input terminal or balanced input ter-
minal, both of which are located on the rear panel.
While switching inputs, the input/output muting circuit is
activated and no sound is generated.