How to Use Sleep Timer
When a tuner with the sleep timer function is
connected to the system control, timer operations are
available. The power can be cut off automatically after
90
-
10 minutes. Setting step is 10 minutes.
1.
Push the "SLEEP" button (item
#18)
during
playback.
2.
Set a desired time by repeatedly pushing the
"SLEEP" button. The time will be changed by
10
minutes step each time the button is pushed.
With the tuner used, various timer playback can be
made. For further details, refer to the manual for the
tuner.
Remote Operations
For reliable operation, use the hand-held remote
control within the basic dimensional area shown on
page
5,
Fig.
3.
Cleaning
The durable finish of the knobs and front panel will
last indefinitely with proper care and cleaning. Never
use scouring pads. steel wool, scouring powders, or
harsh chemical agents, such as lye solution. These
will mar the finish. Clean with a soft, lint-free cloth or
cotton swab slightly dampened with a mild solution of
detergent and
water.
Repacking for Shipment
Should it become necessary to ship your
C-383
for
any reason, use the original packing materials. If
these are no longer available, be sure that adequate
materials, at least equivalent to the original, are used,
Battery Replacement (Fig. 4, page
5)
1.
Open the battery compartment cover on the rear of
the remote control unit. The cover should open
easily if you press on it with your thumb and slide it
in the direction of the arrow.
2.
Place two "AA" size dry batteries in the battery
compartment in accordance with the diagram in
the compartment, then replace the cover.
Incorrect use of batteries may lead to leakage or
rupture. Be sure to follow these guidelines:
A. Always insert batteries into the battery compart-
ment correctly matching the positive
(+)
and
negative
(-)
polarities as shown in the diagram
inside the compartment.
6.
Never mix new and used batteries together.
C.
Both rechargeable and non-rechargeable batteries
are available. Be sure to use your batteries in
accordance with the instructions provided on the
cells.
Repairs
Only the most competent and qualified service techni-
cians should be allowed to service the
C-383.
The
Luxman company and its factory-trained warranty
station personnel have the knowledge and special
equipment needed for repair and calibration of this
precision instrument.
In the event of difficulty, call the
Luxman Authorized
Service Station nearest your home or business. In
many cases, the dealer where you purchased your
Luxman unit will be equipped to provide service.
To Next Page
Loading...
Need help?
General
