9
8. Bi-amplifier indicator (BI-AMP)
Lights up when the bi-amplifier output is selected for the
output mode.
9. Balanced phase inversion indicator
(BAL INVERT)
Lights up when the phases of the balanced input and bal-
anced output are inverse against the preset state of this
unit.
10. External pre indicator (EXT PRE)
Lights up when the external pre switch is set to ON.
11. Line straight indicator (LINE STRAIGHT)
Lights up when the line straight switch is set to ON.
When the line straight switch is set to ON, the loudness
function cannot be operated from the accessory remote
control.
If this switch is pressed, the line straight indicator blinks for 3
seconds to show that this operation cannot be performed.
Perform the loudness function after setting the line straight
switch to OFF.
The loudness function can be toggled ON and OFF only with
the accessory remote control (RA-20).
To Next Page
Loading...
Need help?
General
