Information on this document supersedes all previous versions. Products and documents
subject to change without notice. Products may be discontinued without notice.
LUX-QIG-XMS-1008P
093140920
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685
luxul.com | 801-822-5450
3. Power on the switch.
4. Check to see that the IP address of the computer is within this network segment: 192.168.0.xxx
(“xxx” ranges 2~254. For example, 192.168.0.50). For IP address settings, refer to Appendix 2.
5. Open the Web browser and enter 192.168.0.3. The switch
login window appears, as shown at the right.
6. Enter the user name and password (default user name
and default password are both set as “admin”), and then
click “OK” to login to the switch configuration window.
Click any menu item on the left to view and/or modify the
corresponding settings or functions.
ADVANCED SETTINGS
For login and advanced settings information see the User Guide on luxul.com
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions may cause harmful
interference to radio communications. However; there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Hereby, Luxul, 14203 Minuteman Drive, Suite 201, Draper, Utah, 84020, declares that
this Luxul XAP-1500 is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
For a copy of this report send a self addressed stamped envelope to:
Luxul CE, 14203 Minuteman Drive, Suite 201, Draper, Utah, 84020.