xvii SolsTiS User Manual v10.0
F CE Declaration of Conformity
Note! The attention of the specifier, purchaser, installer,
or user is drawn to special measures and limitations to
use of this equipment, which must be observed when
these products are taken into service to maintain
compliance with the above directives. Details of these
special measures and limitations to use are available on
request, and are also contained in this manual.
The Manufacturer of the Products covered by this Declaration is:
M Squared Lasers Ltd.
The address of the head office is:
1 Kelvin Campus,
West of Scotland Science Park,
Maryhill Road,
Glasgow,
G20 0SP,
UK
The product covered by this declaration is:
SolsTiS, narrow linewidth, tunable CW Ti:Sapphire laser.
The above mentioned product complies with the essential requirements,
which are specified in the directives 2004/108/EC and 2006/95/EC on
the approximation of the Member States relating to electromagnetic
compatibility and electrical safety.
The product of the declaration above has been designed and
manufactured to be in compliance with the requirements of the following
standards and the results of testing and assessment are included in the
Technical Documentation:
EN 60825-1 Edition 2.0 2007-03 Safety of Laser Products
EN 61010-1 Edition 2.0 2001-02 Safety requirements for electrical
equipment for measurement, control and laboratory use
EN 61326-1:2006 (Emissions only) Electrical equipment for
measurement, control and laboratory use. EMC Requirements. General
Requirements.
EN 55011:2007 (Conducted and radiated emissions to Class B)
Equipment electromagnetic disturbance characteristics. Limits and
methods of measurement.
EN 55022:2006 (Conducted emissions) Information technology
equipment. Radio disturbance characteristics. Limits and methods of
measurements
The technical documentation required to demonstrate that the product
meets the essential requirements of the above directives has been
complied and is available for inspection by the relevant enforcement
authorities.
The CE mark was first applied in September 2009.
Signed:
Name: Bill Miller
Authority: Director of Systems Engineering
To Next Page
Loading...