MCSWP40 by MacAllister
30
Product Functions
GB
IE
In more detail...
Product Functions
Intended use
This petrol chain saw MCSWP40 is designated with a maximum
power output of 1.5 kW. The product is intended for cutting logs
with a thickness of max. 370 mm with the guide bar provided. It
must not be used for cutting other materials, such as plastic, stone,
metal or wood that contains foreign objects.The product may only
be used with the guide bar/saw chain combination stated in these
instructions. It is not permitted to use other types or sizes.Vertical
and horizontal cuts can be performed with this product. Longitudinal
sections can only be cut by professionals.This product should not
be used outside of domestic premises e.g. for cutting rewood in
forested areas. The product should not be used on masonry and
materials that are harmful to health.This product is intended for
private domestic use only, not for any commercial trade use. It must
not be used for any purposes other than those described.
Primer
Press the primer (9) 6 times when starting
the product with a cold engine (Fig. 20). Do
not press the primer for warm starts.
Choke lever and fast tickover
1. By pulling out the choke lever (25) fully
(Fig. 20a), the choke is now at CLOSE
position, and the throttle is at fast tickover.
2. By pressing in the choke lever (Fig.
20b), the choke is now at OPEN position
while the throttle is kept at fast tickover.
3. To cancel fast tickover, press and
release the throttle interlock (26) and
throttle trigger (27).
9
Fig. 20
25
25
OPENCLOSE
Fig. 20a Fig. 20b
To Next Page
Loading...
