GB
IE
MCSWP40 by MacAllister
18
Getting Started...
Before you start
Assembly (if not already assembled)
Disconnect the spark plug connector (15) from the spark plug.
Assemble the guide bar and saw chain before operation. Follow the
operating instructions step-by-step and use the pictures provided
as a visual guide to easily assemble the product.
WARNING! Read all the instructions carefully! Do not start
the product before it is completely assembled. Always
wear gloves during assembly!
Chain and guide bar
> Use only the guide bar (4) and saw chain (3) according to the
technical data of the product.
WARNING! Always use a saw chain designed as “low-
kickback” or a saw chain which meets the low-kickback
requirements! A standard saw chain (a chain which does not
have the kickback reducing guard links) should only be used
by an experienced professional operator! Nevertheless,
a low-kickback saw chain does not completely eliminate
kickback! A low-kickback or “safety” chain should never be
regarded as complete protection against injury! Therefore
always use a low-kickback saw chain in conjunction with
other kickback protection devices such as the front guard/
chain brake!
> Place the product on a suitable at surface with the cover (8)
facing upwards.
WARNING! Before removing, ensure the front guard/chain
brake (2) is in the disengaged position (see section “In
more Detail - Chain brake”). If in the engaged position, pull
the front guard/chain brake backwards until it ‘clicks’ into
position.
> Loosen the nuts [6] and remove the cover [8] (Fig. 1/2)
8
8
6
Fig. 1
Fig. 2
To Next Page
