21
Before you start
MTC500 by MacAllister
Getting started...
Connection to the electrical supply
Check the safe condition of the product before plugging the power cable:
> Before switching on, make sure that the voltage of the mains supply is the same
as indicated on the rating plate. This product is designed to operate on 220-240V~
50Hz. Connecting it to any other power source may cause damage.
> This appliance must be earthed. If in doubt, please consult a qualified electrician.
The mains supply shall be fed via a 10A fuse min.
> This machine must be supplied through a residual current device (RCD).
EN
To Next Page
Loading...
