EasyManua.ls Logo

MacDon 9352 - Air conditioning not cooling

MacDon 9352
160 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Form # 46584 Issue 11/06 Web Rev_01
117
TROUBLE SHOOTING
SYMPTOM
PROBLEM
SOLUTION
REF.
Cab Air System See page 112 for possible causes of abnormal high side / low side pressure.
Blower fan will not run.
Burned out motor.
Replace motor.
*
Burned out switch.
Replace switch.
*
Motor shaft tight or
bearings worn.
Repair motor.
*
Faulty wiring - loose or
broken.
Repair or replace wiring.
*
Blower rotors in contact
with housing.
Replace rotors and/or
housing.
*
Blower fan operating but
no air coming into cab.
Dirty fresh air filter.
Evaporator clogged.
Clean filter.
Clean evaporator.
110
111
Air flow passage
blocked.
Remove blockage.
---
Heater not heating.
Heater shut-off valve at
engine closed.
Open valve.
21
Defective thermostat in
engine water outlet
manifold.
Replace thermostat.
*
Heater temperature
control defective.
Replace control.
*
No thermostat in engine
water outlet manifold.
Install thermostat.
*
Odour from air louvers.
Plugged drainage hose.
Blow out hose with
compressed air.
---
Dirty filters.
Clean filters.
110, 111
Air conditioning not
cooling.
Low refrigerant level.
Add refrigerant
*
Switch contacts in
thermostat burned
excessively, or sensing
element defective.
Replace thermostat.
*
Clutch coil or relay
burned out or
disconnected.
Check current flow to
clutch or relay. Replace
if inoperative.
*
Condenser fins plugged.
Clean condenser.
79
Blower motor discon-
nected or burned out.
Check current flow to
blower motor. Repair or
replace if inoperative.
*
* See your Windrower Dealer.

Table of Contents

Related product manuals