UNLOADING AND ASSEMBLY
Form 169078 Revision C
STEP 19. LUBRICATE THE
HEADER
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
f. Refer to the illustrations on following pages for
lubrication points.
Pressure (EP2) Performance With
1% Max Molybdenum Disulphide
(NLGI Grade 2) Lithium Base
AUGER SHAFT BEARING (1 PLC)
REEL SHAFT BEARING (1 PLC)
To Next Page
Loading...
