MacDon A30-D - Auger Stripper Bar Clearance; Reel Tine to Header Pan Clearance

PRE-DELIVERY CHECKS
Form 169078 Revision C
46
B. AUGER STRIPPER BAR
CLEARANCE
a. Check for signs of auger flighting rubbing
stripper bars after run-up.
b. Check clearance between auger flighting and
stripper bars.
NOTE
The auger should clear the stripper bars
on the auger pan by approximately
1/32 - 5/32 in. (1 - 4 mm). Shimming the
stripper bars may be required.
C. REEL TINE TO HEADER PAN
CLEARANCE
IMPORTANT
The above dimensions are provided as
guidelines only. Tines may “slightly”
contact the guards but not the knife
sections or the auger pan.
a. Rotate reel slowly by hand, and check tine
clearance at knife and pan. Flex tines to
simulate crop-loaded position to ensure tine
clearances to knife sections and auger pan are
adequate for working conditions.
b. Check that the reel rotates freely.
NOTE
In order to set the reel as close as
possible to the knife and pan, it may be
necessary to trim a small number of tines
that appear exceptionally long.
FLEX TINE BACK
0.08 - 0.39 in.
(2 - 10 mm)
0.08 in.
(2 mm)
1/32 - 5/32 in.
(1 -
4 mm)
CLEARANCE
1/32 - 5/32 in.
(1
- 4 mm)
CLEARANCE
1/32 - 5/32 in.
(1 -
4 mm)
CLEARANCE
AUGER