214923 8 Revision A
2.2 Removing Driveline Guard
1001392
A
Figure 2.6: Driveline Guard
1. Slide the two halves of the driveline shaft apart.
2. On the guard being replaced, use a slotted screwdriver to
release grease fitting/lock (A).
Figure 2.7: Driveline Guard
3. Rotate the driveline guard locking ring (A) counterclockwise
using a screwdriver until the lugs (B) line up with the slots
in the guard.
4. Pull the guard off the driveline.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
