How to troubleshoot insufficient draper speed on MacDon Farm Equipment?
If there is insufficient draper speed, try the following: increase the control setting, increase the relief pressure to the recommended setting, adjust to the correct speed for the windrower model, replace the gear pump, or adjust to increase the setting.
What to do if the draper will not move on MacDon D60?
If the draper will not move, try the following: tighten the drapers, loosen the draper and clean the rollers, loosen the draper and clear any obstruction, replace the roller bearing, fill the windrower reservoir to the full level, or adjust the relief setting.
How to stop the knife from plugging on MacDon D60 Farm Equipment?
To prevent knife plugging, try the following: lower the reel or move it rearward, increase ground speed, adjust the hold-down, or replace the knife section.
What causes excessive breakage of sickle sections or guards on MacDon D60 Farm Equipment?
If you're experiencing excessive breakage of sickle sections or guards on your MacDon Farm Equipment, there are several potential causes. Adjust the sickle hold-downs. Raise the cutterbar using the skid shoes if operating too low in stony conditions. Adjust float springs for lighter float if the float is set too heavy. Straighten or replace bent or broken guards. Flatten the header angle if it is too steep.
Why is there hesitation in the flow of bulky crop with my MacDon D60?
If you're experiencing hesitation in the flow of bulky crop with your MacDon Farm Equipment, the header angle may be too flat, so steepen it. There may be a material overload on the drapers, so increase the side draper speed. Install an upper cross auger. Add flighting extensions.
Why does material accumulate inside or under the front edge of the draper on MacDon Farm Equipment?
If material is accumulating inside or under the front edge of the draper on your MacDon Farm Equipment, it's likely due to the deck height being improperly adjusted. Adjust the deck height to resolve this issue.
Why is the divider rod running down standing crop on MacDon Farm Equipment?
If the divider rod is running down standing crop when using MacDon Farm Equipment, it may be because the divider rods are too long. Remove the divider rod to resolve this issue.
What to do if MacDon D60 is excessively bouncing at normal field speed?
Excessive bouncing at normal field speed with MacDon Farm Equipment can be caused by a float set too light. To fix this, adjust the header float.
What causes strips of uncut material with MacDon Farm Equipment?
Strips of uncut material when using MacDon Farm Equipment can be due to crowding uncut crop or broken sickle sections. Allow enough room for the crop to be fed to the cutterbar, and replace any broken sickle sections.
How to fix MacDon D60 Farm Equipment that does not pick up down crop?
If your MacDon Farm Equipment is not picking up down crop, the cutterbar may be too high, the header angle too flat, or the reel may be too high or too far back. The ground speed might be too fast for the reel speed, or the reel fingers may not be lifting the crop sufficiently. Lower the cutterbar and reel, steepen the header angle, move the reel forward, reduce the ground speed or increase the reel speed, and increase the finger pitch aggressiveness. You can also install lifter guards.
General| Brand | MacDon |
|---|---|
| Model | D60 |
| Category | Farm Equipment |
| Language | English |
To Next Page
