What to do if MacDon D60 is excessively bouncing at normal field speed?
Excessive bouncing at normal field speed with MacDon Farm Equipment can be caused by a float set too light. To fix this, adjust the header float.
Why is the divider rod running down standing crop on MacDon Farm Equipment?
If the divider rod is running down standing crop when using MacDon Farm Equipment, it may be because the divider rods are too long. Remove the divider rod to resolve this issue.
How to prevent crop loss at the cutterbar of MacDon D60 Farm Equipment?
To prevent crop loss at the cutterbar: lower the cutterbar, increase the header angle, lower the reel, move the reel forward, reduce ground speed or increase reel speed, increase finger pitch aggressiveness, and/or install lifter guards.
How to fix ragged or uneven cutting of crop with MacDon Farm Equipment?
To address ragged or uneven cutting, try the following: adjust the hold-downs, replace all worn and broken cutting parts, check the engine speed of the windrower, reduce ground speed or increase reel speed, adjust the reel position and finger pitch, lower the cutting height, steepen the header angle, straighten a bent knife and align the guards, align the guards, install stub guards or move the reel forward.
How to correct an uneven windrow in any crop condition with MacDon D60?
To correct an uneven windrow, try raising the reel, reducing ground speed or increasing draper speed, or reducing reel speed.
How to stop the knife from plugging on MacDon D60 Farm Equipment?
To prevent knife plugging, try the following: lower the reel or move it rearward, increase ground speed, adjust the hold-down, or replace the knife section.
What to do if the draper will not move on MacDon D60?
If the draper will not move, try the following: tighten the drapers, loosen the draper and clean the rollers, loosen the draper and clear any obstruction, replace the roller bearing, fill the windrower reservoir to the full level, or adjust the relief setting.
How to troubleshoot insufficient draper speed on MacDon Farm Equipment?
If there is insufficient draper speed, try the following: increase the control setting, increase the relief pressure to the recommended setting, adjust to the correct speed for the windrower model, replace the gear pump, or adjust to increase the setting.
How to reduce excessive header vibration on MacDon Farm Equipment?
To reduce excessive header vibration, consider the following: adjust the hold-downs, adjust the knife timing, check the engine speed of the windrower, replace the knife, tighten or replace parts, or straighten the cutterbar.
Why are heads shattering or breaking off when using MacDon D60 Farm Equipment?
Heads shattering or breaking off in your MacDon Farm Equipment can occur if the reel speed is too fast, the reel is too low, or the ground speed is too fast. To resolve this, reduce the reel speed, raise the reel, or reduce the ground speed. Operating at night when humidity is higher can also help if the crop is too ripe.
General| Brand | MacDon |
|---|---|
| Model | D60 |
| Category | Farm Equipment |
| Language | English |
To Next Page
