MacDon M105 - Step 8. Connect Batteries

UNLOADING AND ASSEMBLY
169558 20 Revision D
STEP 8. CONNECT BATTERIES
The batteries should conform to the following
specification:
Rating BCI group CCA Volt
Heavy Duty, Off-Road,
Vibration Resistant
31A or 29H
650
(min)
12
a. Open engine compartment hood to highest
position.
b. A battery main disconnect switch is located on
the battery tray. Ensure switch is switched to
POWER OFF.
IMPORTANT
BATTERY IS NEGATIVE
GROUNDED.
Always connect starter cable to the
positive (+) terminal of battery, and
battery ground cable to negative (-)
terminal of battery. Reversed polarity
in battery or alternator may result in
permanent damage to electrical
system.
c. Attach negative (black) cable clamps (D) to
negative post on batteries, and tighten clamps.
d. Attach positive (red) cable clamps (E) to positive
post on batteries, and tighten. Re-install plastic
covers onto clamps.
e. Switch battery switch to ON.
f. Close engine compartment hood.
C
E
D
B
A