UNLOADING AND ASSEMBLY
169558 24 Revision D
b. Locate boot (D) on lift linkage (E), and re-install
pin (C). Pin may be installed from either side of
boot.
c. Secure pin (C) with hairpin.
d. Repeat for opposite side.
III. ATTACH HEADER
a. Remove hairpin on pins (F), and remove pins
from header legs.
IMPORTANT
For machines equipped with the hydraulic
center-link, it may contact the header as
the windrower approaches the header for
hook-up.
b. If necessary, relocate the pin (J) at the frame
linkage as required to raise the center-link (G)
so that the hook (H) is above the attachment pin
on the header.
CAUTION
Check to be sure all bystanders have
cleared the area.
c. Start engine, and activate HEADER DOWN
button on the Ground Speed Lever (GSL) to fully
retract header lift cylinders.
d. Slowly drive windrower forward so that boots (D)
enter header legs (K). Continue to drive slowly
forward until lift linkages contact support plates
in the header legs, and header nudges forward.
e. Ensure that lift linkages are properly engaged in
header legs, contacting support plates.
(continued next page)
D
E
C
D
K
H
G
J
F
HEADER UP
HEADER TILT UP
HEADER DOWN
HEADER
TILT DOWN
To Next Page
