32
Note:
1: If you need to record all day long, set TIME1 as 00:00-24:00 &
state is on; set TIME2 as off.
2: When setting time in WEEK, several days can be set at
the same time. When Reviewing a certain channel’s timing,
only the current day will be highlighted.
In CH option select the related channel. In MODE there are CBR
(audio/video) and VBR (audio/video). AV is audio and video synchronization,
Video is the mode without audio (when there is no audio input use this way to
save HDD space).When in CBR, Framerate is Real time, Bitrate is the related
maximum data flux. Use direction key to select the different bitrates. When in
VBR, Framerate 1f/s-25f/s are selectable. Video Loss on means that alarm will
be on when the video is lost, and also trigger the relay device.
Select the relevant channel in CH(this recorder has 4-Chalarm
input). TYPE has NO(normal on/NC(normal close（ electric output
method） . If the number in RECORD is selected, recording would
be started automatically when there is alarm input. If the alarm
output port is chosen, it will trigger corresponding equipment when
there is alarm input. DELAY means to lengthen the recording time
after receiving alarm signals（ 10、 20、 30、……90SEC） . When the
outside alarm is canceled, the system will lengthen the recording
time automatically before closing alarm and relay output. When
TIME1 、 TIME2 are open, within the time of the setting the
recording will be triggered by alarm signals. The beginning time
should be earlier than the ending time, the setting in TIME2
Image
Alarm setting
CH 1
TYPE NORMAL CLOSE
RECORD 1 2 3 4
ALMOUT 1 2 3
ADDR 008
DELAY 60SEC
TIME 1 08:00 AM – 08:00 PM
STATE OFF
TIME 2 08:00 AM – 08:00 PM
STATE OFF
ALMSVR IP 192.168.000.117
SAVE CANCEL
IMAGE SETTING
CH 1
MODE CBR AV
FRAMERATE REAL
BITRATE 1024K
VIDEO LOSS OFF
COVERED OFF
VIDEO SET DEFAULT
TITLE 01 ON
CYCLE OFF
SAVE CANCEL
To Next Page
Loading...