59
Chapter 6 Serial port operation
1． System setting of the Terminal
The system’s operation can also be done through RS232 port. The specific operation is as following： First, copy “Terminal” and
“system upgrade program” to the computer. Connect the computer with the DVR through RS232 port. Run “Terminal” program and
create the connection between the computer and the DVR.
The setting information for the connection is: Baud rate— 115200bps
Data bit— 8 digits
Stop bit— 1 digit
Check — no need
Control on data flow— no
Yo u can log in by username admin (default user with administrator power ) for the serial port login.
Login steps：
Press any key to enter the login interface， which showing as following：
＿ Username： admin
Input the name; press the “enter” key. Then, input the password as following：
＿ Password： admin
.
If the username and password are correct, system enter serial port management menu interface. The detailed functions are the
same as the menu setting.
2． Serial port upgrading operation
After the setting of above operation, please follow the below operation：
Press any key to enter login interface as following：
＿ Username： admin
To Next Page
Loading...