Page 5-40
200 BENCH PROCEDURES
VALVE YOKE GUIDE PIN REMOVAL
Refer to Figure 5-52.
1. To remove pin, use valve yoke guide pin
puller kit PT6575 and extractor PT6570-11
(7/16 inch).
2. Install extractor over guide pin and position
extractor lock over extractor.
3. Using slide hammer, remove pin.
Figure 5-52 — Valve Yoke Guide Pin Removal
VALVE YOKE GUIDE PIN INSTALLATION
Refer to Figure 5-53.
If new pin is required, use valve guide pin installer
J 37809 to drive pin into cylinder head. Guide pin
will be at correct height when tool bottoms on
cylinder head.
Figure 5-53 — Valve Yoke Guide Pin Installation
1. Extractor lock (part of PT6570-11)
1. Valve yoke guide pin 2. J 37809
5-101.bk Page 40 Friday, March 17, 2006 11:05 AM
To Next Page
Loading...
