Page 4-12
200 ENGINE DISASSEMBLY
[222 KD] FUEL NOZZLE INLET
TUBE ASSEMBLY
Refer to Figure 4-13.
1. Loosen six tube sleeve nuts (6) at the
injection pump. Be careful to avoid twisting
lines while loosening nuts.
2. Loosen brackets (3 and 5) by removing
retaining hardware.
3. Loosen tube sleeve nuts (1) and tube
clamping screws at the cylinder heads and
remove front (4) and rear (2) tube
assemblies. Cap all lines and fittings to
prevent contaminants from entering the
system.
Figure 4-13 — Fuel Inlet Tube Assembly Removal
200353a
11
1
2
1
3
2
1
3
1
4
5
6
7
8
9
10
5
1. Nozzle fuel inlet tube and sleeve nut
2. Rear fuel inlet tube assembly
3. Bracket/insulator (tube clamp)
4. Front fuel inlet tube assembly
5. Bracket/insulator (tube clamp)
6. Sleeve nut
7. Oil filler feed tube
8. Oil filler feed tube bracket
9. Capscrew
10. Exhaust manifold
11. Capscrew
5-101.bk Page 12 Friday, March 17, 2006 11:05 AM
To Next Page
Loading...
