Mack E7 - Disassembly

200 BENCH PROCEDURES
Page 5-55
Figure 5-67 — Oil Cooler Assembly
Disassembly
Refer to Figure 5-67.
1. Remove coolant inlet end cap (20) by
removing six capscrews (19).
2. Remove coolant outlet end cap (2) by
removing six capscrews (26).
3. Remove bundle (22) from coolant inlet end
of housing (24).
4. Remove O-ring (3) from coolant outlet end of
housing.
5. Clean gasket material from all surfaces.
200556a
24
23 22 21
20
19
25
26
27
1
2
3
4
5
7
6
8
9
10
11
12
13
14
15
17
18
16
1. Gasket
2. Coolant outlet end cap
3. O-ring
4. Mounting flange
5. Clamps
6. Coupler
7. Gasket or O-ring
8. Washer
9. Capscrew
10. Oil outlet tube
11. O-ring
12. Capscrew
13. Washer
14. Oil supply head
15. Capscrew
16. Washer
17. O-ring
18. Pipe plug
19. Capscrew
20. Coolant inlet cap
21. Gasket
22. Bundle
23. Gasket
24. Housing
25. Gasket
26. Capscrew
27. Capscrew
5-101.bk Page 55 Friday, March 17, 2006 11:05 AM